Create your own light switch cover
Your pet. Your idea. Your light switch.
A few words or a photo of your pet, create the character below, place the switch where you like — we 3D print it in Montpelier, Ohio. $24.99 each. 2 for $39.99 + free shipping.
This is Link. One photo in, a cover out. See it
- One solid 3D-printed plate
- Art UV printed on the plastic
- Fits any toggle switch
- Made to order in Ohio
Creating your cover…
Sharpening the crayons…
About 10 seconds. Hang tight — it is worth it.
Let's get started
Pick your path. Two ways in, one cover out.
A few words, or a photo of your pet — either one turns into your light switch cover in about a minute. There is no wrong pick, and you can always come back and try the other.
Tap one of the two cards to begin
Pick a style — then say what it should be
That is your 5 drawings for today
Or, four other ways on:
Or come back tomorrow — the counter resets every day.
Place the switch
Drag the picture to move the switch. It snaps to the middle; keep it in a solid part of the character.
Leave it blank for a fresh take on the same words. Each try uses one of your drawings.
Added to your cart ✓
Your drawings
Tap one to put it back on the wall.
Ask for help
Mike reads these himself and emails you back — usually the same day.
Good to know
- How big will it be?
- As big as the character needs to be for the switch to fit inside it, usually 6 to 9 inches tall. The size shows on the picture.
- What if the switch does not fit?
- The page tries up to three takes on its own. If none works, you can put it on a standard plate, or change the words a little and try again.
- Shipping and returns
- $3.99 shipping, free over $50.00. Custom covers are made just for you, so they are not returnable — the Safe Delivery Guarantee covers anything that arrives damaged.